Evo 8.2

Space shortcuts

Page tree

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

  1. Create curves for plate output using either the ColorFlow or Harmony software.
    • See the Prinergy Evo Installation Guide for information about installing Harmony software and the Harmony User Guide for information about creating calibration curves with Harmony software.
    • See the ColorFlow documentation for information about creating curves with ColorFlow software.
  2. Create an Output process template.
  3. In the Calibration & Screening section, make one of these choices:
To apply the current ColorFlow behavior, select the ColorFlow Color Relationship Management (CRM) check box for output process templates.
  • Curves are selected according to color setup, device, device condition, and so on.
  • Except for Minimum Dot Size, all curve controls in the Calibration panel are disabled.
  • The Minimum Dot Size control is active and takes effect for the curves selected by CRM.
To select a Harmony curve, clear the ColorFlow Color Relationship Management check box and, in the Calibration panel, from the Curve Source menu, select Harmony.
  • Harmony will be available in the Curve Source menu only if there are Harmony curves available for selection.
  • The available Harmony curves and %%NONE%% are listed for selection in the Plate Curve and Print Curve menus.
     Prinergy Evo reads the list of calibration curves from the Harmony database installed on the Prinergy Evo server computer.
  • The Harmony Medium and Minimum Dot Size controls are active unless you have selected %%NONE%% for both Plate Curves and Print Curves, in which case the Minimum Dot Size value is zero and the control is inactive.
  • Harmony curve settings are applied to the job per current behavior.
To select a ColorFlow curve, clear the ColorFlow Color Relationship Management check box and, in the Calibration panel, from the Curve Source menu, select either ColorFlow Approved Snapshot or ColorFlow Current State.
  • The available print curve names or plate curve names made visible by ColorFlow from the selected source (approved snapshot or current state) and %%NONE%% are listed for selection in the Plate Curve and Print Curve menus.
    Prinergy Evo reads the list of calibration curves from the ColorFlow database installed on the Prinergy Evo server computer. 
  • The Harmony Medium control is inactive.
  • The Minimum Dot Size control is active and takes effect for any selected curves.
  • Any Screening Mode selection is allowed.
  • No labels