Begin the migration process by migrating a few process templates that use Harmony curves. Follow the steps below for each process template.
- In Workshop's Process Template Editor:
- Open the process template for editing.
- Open the Calibration and Screening panel.
- Record the Harmony Print Curve and Plate Curve names.
- Close the process template without saving.
- In ColorFlow:
- Import the print curve and select Show in Prinergy Print Curves. See Importing a Harmony print calibration curve.
- Import the plate curve and select Show in Prinergy Plate Curves. See Importing a Harmony plate calibration curve.
- In Prinergy Administrator (UADM):
- From the Tools menu, select Migrate Process Template Curves.
- Click OK.
- When the Curve Migration Complete message appears, click OK.
- (Optional) Check the migration in Process Template Editor:
- Open the process template for editing.
- Open the Calibration and Screening panel.
- Confirm that:
- Curve Source: ColorFlow Current State is selected
- Print Curve and Plate Curve names are the same as before, except that %% NONE %% is replaced by None.
- Close the process template without saving.
Note: If Curve Source: Harmony remains selected, one or both of the Harmony curves could not be found in ColorFlow. Close the process template without saving and repeat the process.