Evo 8.2

Space shortcuts

Page tree

Versions Compared

Old Version 1

changes.mady.by.user user-3af32

Saved on

compared with

New Version 2

changes.mady.by.user user-f48d1

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Published by Scroll Versions from space EVO and version 8.2
  1. Create curves for plate output using either the ColorFlow or Harmony software.
    • See the Prinergy Evo Installation Guide for information about installing Harmony software and the Harmony User Guide for information about creating calibration curves with Harmony software.
    • See the ColorFlow documentation for information about creating curves with ColorFlow software.
  2. Create an Output process template.
  3. In the Calibration & Screening section, make one of these choices:
To apply the current ColorFlow behavior,
select
enable the ColorFlow
Color Relationship Management (CRM) check box for
pane in the output process
templates
template. 
  • Curves are selected according to screening-related parameters within the process template, such as: color setup, device, device condition, and so on.
  • Except for Minimum Dot Size, all curve controls in the Calibration and Screening panel are disabled.
  • The Minimum Dot Size control is active and takes effect for the curves selected by ColorFlow Color Relationship Management (CRM).
To select a Harmony curve, clear the ColorFlow
Color Relationship Management check
pane check box and
,
  • Harmony will be available in the Curve Source menu only if there are Harmony curves available for selection.
    • configure your desired Harmony settings in the Calibration
    panel, from the Curve Source menu, select Harmony.
    and Screening panel.
    • The available Harmony curves and %%NONE%% are listed for selection in the Plate Curve and Print Curve menus.
       Prinergy Evo reads the list of calibration curves from the Harmony database installed on the Prinergy Evo server computer.
    • The Harmony Medium and Minimum Dot Size controls are active unless you have selected %%NONE%% for both Plate Curves and Print Curves, in which case the Minimum Dot Size value is zero and the control is inactive.
    • Harmony curve settings are applied to the job per current behavior
    .To select a ColorFlow curve, clear the ColorFlow Color Relationship Management check box and, in the Calibration panel, from the Curve Source menu, select either ColorFlow Approved Snapshot or ColorFlow Current State.
  • The available print curve names or plate curve names made visible by ColorFlow from the selected source (approved snapshot or current state) and %%NONE%% are listed for selection in the Plate Curve and Print Curve menus.
    Prinergy Evo reads the list of calibration curves from the ColorFlow database installed on the Prinergy Evo server computer. 
  • The Harmony Medium control is inactive.
  • The Minimum Dot Size control is active and takes effect for any selected curves.
    • Any Screening Mode selection is allowed
    • .