Begin the migration process by migrating a few process templates that use Harmony curves. For initial testing, save a copy of a commonly used output process template and migrate it. Follow the steps below for each process template.
- In Workshop's Process Template Editor:
- Open the process template for editing.
- Open the Calibration and Screening panel.
- Record the Harmony Print Curve and Plate Curve names.
- Leave the process template open for step 3.
- In ColorFlow:
- Import the print curve and select Show in Prinergy Print Curves. See Importing a Harmony print calibration curve.
- Import the plate curve and select Show in Prinergy Plate Curves. See Importing a Harmony plate calibration curve.
- In Process Template Editor:
- Open the Calibration and Screening panel.
- Select Curve Source: ColorFlow Current State.
The Print Curve and Plate Curve selections remain the same, except that %% NONE %% is replaced by None.
Note: If either curve selection changes from a named Harmony curve to None, the Harmony curve name could not be found in ColorFlow. Close the process template without saving and repeat the process. - Save and close the process template.