Page tree

You can adjust the measured tint densities on plate after some changes have occurred to a plate line in an existing plate setup. 

Note: You must have imaged a plate control strip using this particular combination of device type, plate type, screening, and plate line.

  1. Click the Plate Curves tab.
  2. Click the plate curve that you want to remeasure.
  3. In the Data panel on the right, in the Measured Plate Response section, click the desired Tint In row and enter the measured plate response. 
  4. To modify the Tint In values, click Tint Set and make your changes.
  5. Click Apply.