You can import Harmony derived calibration curves and transfer curves into ColorFlow Plate Curves for use by Prinergy.
- In the Plate Curves tab, under the Harmony Curves section, click Import.
- Locate and select your Harmony file, and then click Open.
- By default, ColorFlow browses to the directory containing the CalCurve.hmy file used by Harmony and Prinergy. Select this file for the active Harmony database.
- The Import Harmony Curves table shows all of the Harmony plate calibration curves in the file.
- If the curve you are looking for does not appear in the Import Harmony Curves table, or if you wish to import all types of Harmony calibration curves into ColorFlow, select Show Paper and Film Calibration Curves. See also Calibration Curve Types in Harmony, ColorFlow and Prinergy.
- Select the curve(s) that you want to import, using standard multiple selection controls.
- Click OK.
Note: if a curve cannot be imported, the curve definition is most likely not supported by ColorFlow. For example, Harmony curves with a maximum tone of less than 100% are not supported by ColorFlow. - To make a curve visible in the Plate Curve list control in the Calibration and Screening panel of a Prinergy process template:
- Find the curve in the Harmony Curves table (it will be selected after import). If you cannot find the curve, select Show Paper and Film Curves. See also Calibration Curve Types in Harmony, ColorFlow and Prinergy.
- Select Show in Prinergy Plate Curves.
- (Optional) View the imported curve by clicking the Harmony Curves icon
in the right panel - (Optional) Updating a Harmony Plate Curve.
Imported curves will be available in Prinergy from Curve Source: ColorFlow Current State. If you want all imported Plate Harmony Curves to also be selectable from Curve Source: ColorFlow Approved Snapshot, select the Use for Approved Snapshot check box.