Migrating selected process templates and their Harmony curves to ColorFlow

Begin the migration process by migrating a few process templates that use Harmony curves. Follow the steps below for each process template.

1. In Workshop's Process Template Editor:
   1. Open the process template for editing.
   2. Open the Calibration and Screening panel.
   3. Record the Harmony Print Curve and Plate Curve names.
   4. Close the process template without saving.
2. In ColorFlow:
   1. Import the print curve and select Show in Prinergy Print Curves. See Importing a Harmony print calibration curve.
   2. Import the plate curve and select Show in Prinergy Plate Curves. See Importing a Harmony plate calibration curve.
3. In Prinergy Administrator (UADM):
   1. From the Tools menu, select Migrate Process Template Curves.
   2. Click OK.
   3. When the Curve Migration Complete message appears, click OK.
4. (Optional) Check the migration in Process Template Editor:
   1. Open the process template for editing.
   2. Open the Calibration and Screening panel.
   3. Confirm that:
      1. Curve Source: ColorFlow Current State is selected
      2. Print Curve and Plate Curve names are the same as before, except that %% NONE %% is replaced by None.
   4. Close the process template without saving.

Note: If Curve Source: Harmony remains selected, one or both of the Harmony curves could not be found in ColorFlow. Close the process template without saving and repeat the process.