In the Press Runs workspace, select a page, and, in the Properties pane, select the Template Page tab to display its settings. Template pages define the positioning of content pages on press-run layouts.
Page Number, Section | The front and back page numbers and the section numbers determine the flow of the run-list pages. When you duplicate or copy ganged or independent pages, the template page numbers are retained. However, if you duplicate an entire press run that contains a layout, the page numbers increment sequentially in the new press run. |
Finished Page Size, W, H | The final width and height of the printed and trimmed product page. The default dimensions are defined on the General tab in the Preferences dialog box. |
Reference Point | The corresponding corner or center point on both the sheet and the page, from which Position on Sheet offsets are measured. This point remains constant when rotation is applied. |
Position on Sheet, H, V | The horizontal and vertical offset distances between the reference point and the lower-left page corner |
Locked | Imposition pages are always locked into their Position on Sheet and Reference Point, which is always the lower-left corner. Rotation can be applied, because it does not change the reference point. |
Page Orientation | The head direction of the template page, which can be up, right, down, or left |
Content Bleed Limits | The maximum bleed to allow on each page edge. By default, all four edges use the default bleed limit. To edit the values, use the check boxes:
|