Requirements:

• Proofer controller—whenever possible, the same proofer controller that will run this proofer for regular production
• Proofer—properly set up (including the latest firmware) and added in Kodak Proofing Software via the Add Proofer wizard. For instructions, see the applicable topics.
• Spectrophotometer—ready to perform measurements and an adequate supply of media is loaded on the proofer. For instructions, see the applicable topics.
• Time—several hours. Unless otherwise indicated, always allow at least 30 minutes of drying time after each print.

Note: If you exit before finishing, the next time that you start the wizard, you can continue from where you stopped.

1. In Proofer Viewer, from the Configure menu, select Media Configuration.
2. Click New.

The Media Configuration wizard starts to guide you through the process of creating a new media configuration.

Next: Perform the steps as instructed by the wizard. The side pane also displays useful information about each step.