You can use the Ruler tool to measure information on the layout such as start and end points, horizontal and vertical deltas, distance, and angle.

1. On the main Pandora toolbar, click the Ruler tool.
   The cursor changes to a crosshair indicating the measurement start point.
2. Click to start the measurement.
   The cursor changes to a crosshair indicating the measurement end point.
3. Click to end the measurement.
    
4. The status bar displays the following information:
   • The start and end points: 
   • The horizontal and vertical distance of the line: 
   • The measurement distance and angle: 

Note: If the status bar does not contain this information, you may need to adjust the screen resolution of your monitor.