Prinergy Evo software detects all of the Kodak proofers on the network. Before you can use a proofer, add it in the Select Kodak Proofers dialog box. When you have successfully added a proofer, it appears in the output from PDF, output from imposition, and output from PostScript process templates. To do this | Do this |
|---|
Add a Kodak proofer | - In the Prinergy Evo Administrator, click the Tools tab.
- Click Kodak Proofers.
- In the Select Kodak Proofers dialog box, select one or more proofers in the Visible Kodak Proofers list and click
|
 Image Removed -
 Image Added to use the proofers.
To select all of the proofers in the Visible Kodak Proofers list, click
|
 Image Removed -
 Image Added.
If the name of the proofer that you want does not appear in the Visible Kodak Proofers list (this may happen if the proofer is in a different subnet than the Prinergy Evo Administrator), you can add its name by clicking Use.
Note: When manually adding the name of a proofer, ensure you type its name correctly. Otherwise, the server will not correctly appear in the Process Template Editor. - Click OK.
Important: Before the proofers are available to use, restart the Prinergy Evo Administrator by clicking Restart on the System tab. The restart process may take a few minutes. - To double-check that the server has been successfully added, open the Process Template Editor in Prinergy Evo software and complete the following steps:
- Open an output from PDF process template.
- From the Output To list, select Kodak Proofers.
- In the Device section, ensure that the proofers you just added appear in the Proofer Name list.
| Remove a Kodak proofer | - In the Prinergy Evo Administrator, click the Tools tab.
- Click Kodak Proofers.
- In the Select Kodak Proofers dialog box, select one or more proofers in the Kodak Proofers to Use list and click Remove.
- Click OK.
Important: After the proofers are removed, restart the Prinergy Evo Administrator by clicking Restart on the System tab. The restart process may take a few minutes.
|
| 