...
| language | en |
|---|
You can create custom validation rules on the layout job form to check layout creation data. All layout tickets must pass the validation rules. Otherwise, the layout creation process fails.
A validation rule can check that the press sheet is narrower than the press size. For example, you can set validation rules to enable layout creation if the following conditions exist at the same time:
- The press sheet width or die width is less than 42 inches (1067 mm)
- The press sheet width is greater than or equal to the die width
To create a more complex expression, use brackets to group a set of statements. To add brackets before and after a set of statements, select [ and ] from the menu before the first and last statements you wish to make into a single expression. For example, the following validation rule requires two statements to ensure that two different plates can be used only with the specified presses.
...
| language | zh |
|---|
您可以在版式作业表上创建自定义的验证规则，以检查版式创建数据。 所有版式传票必须通过验证规则的检验。 否则，版式创建过程将失败。
验证规则可以检查印张宽度是否小于印刷尺寸。 例如，如果同时出现以下情况，您可以设置验证规则以启用版式创建：
- 印张宽度或刀版宽度小于 42 英寸（1067 毫米）
- 印张宽度大于或等于刀版宽度
...