...
| language | en |
|---|
Unlike traditional plates, certain types of gravure cylinders or flexographic sleeves have no leading edge; they are continuous. When you create staggered layouts for a cylindrical imaging area, the height of the layout is often larger than the circumference of the cylinder. When representing the cylinder on a flat plane in the layout, the software must "wrap" the layout by copying parts of artwork that hang off the top of the substrate, and adding them to the bottom of the substrate.
Note: To avoid artifacts at the boundary of the layout, you must use a workflow system such as Prinergy Workflow or Prinergy Evo Workflow that supports seamless screening.
- Create a step-and-repeat layout.
- Right-click the layout and select Edit to open the Step & Repeat dialog box.
- In the Layout area, select Wrap Top to Bottom.
Artwork that partially overhangs the top edge of the substrate is cropped at the substrate edge, and the cropped data is positioned along the bottom of the substrate so that no data is lost.
The overhanging row still appears as an empty box that indicates where artwork will be cropped on output. - Click OK.
Note: If you wrap using a die, you must place the die on the layout, snap your artwork to the die, and then remove the die and wrap the layout.
...
| language | zh |
|---|
与传统的印版不同，某些类型的凹版印辊或柔性版套筒是没有前缘且连续的。 为圆柱成像区域创建交错版式时，通常，该版式的高度要大于圆柱体圆周。 在版式的平面上显示圆柱体时，Pandora 软件必须通过复制悬停在承印物顶部的页面部分并将它们添加到承印物底部来“打包”该版式。
注意：为避免版式边界的人工痕迹，必须使用支持无缝加网的工作流程系统（如印能捷工作流程或印能捷演化版工作流程）。
- 创建多重拼贴版式。
- 右键单击版式并选择“编辑”以打开“多重拼贴”对话框。
- 在“版式”区域中，选择“从上到下换行”。
在承印物顶部边缘多出的页面部分将在承印物边缘裁切，且裁切的数据沿着承印物底部放置，所以不会丢失任何数据。
多出的行仍然显示为指示输出时将裁剪页面位置的空白框。 - 单击“确定”。
...