The information in the following table applies to software that is commonly integrated with Prinergy Workflow.
Note: If you are upgrading your Prinergy Workflow system and the output device does not work after the upgrade, make sure that you are using the correct version of the Print Console or Xpo software for your operating system.
Versions compatible with Prinergy 8.1
Prinergy Business Link software
InSite Creative Workflow
5.0.1 or later
InSite Prepress Portal software
7.0.1 or later
Note: If InSite Prepress Portal is integrated with Prinergy, the minimum Prinergy version supported for a direct upgrade to Prinergy 8.1 is Prinergy 6.x integrated with InSite Prepress Portal 7.x. If InSite Prepress Portal is integrated with Prinergy 5.2 or 5.3, you will need to upgrade Prinergy to version 6.x and InSite Prepress Portal to version 7.x before upgrading Prinergy to version 8.1.
|Prinergy Cloud software|
Important: You must uninstall the Prinergy Cloud software before upgrading to Prinergy 8.0.2 and re-install Prinergy Cloud after the upgrade to Prinergy 8.0.2 is completed. Therefore, you must coordinate with your Kodak service representative before you upgrade.
Prinergy Evo TIFF Downloader software
3.2 or later (To be able to receive 1-bit TIFF files from Prinergy)
Prinergy Evo software
For similar results processing PDF files with Prinergy Evo, it is recommended that Prinergy Workflow and Prinergy Evo software be at the same RIP version.
Note: Adobe PDF Print Engine 3.6 is not available in Prinergy Evo 6.1.3 or later.
Preps digital imposition software
Prinergy Packaging Layout Automation software
Kodak Proofing Software
6.2 or later
Kodak Spotless Solution (4 color)
1.0 or later
Prinergy Hot Standby with Double-Take software
Double-Take 5.3 (Windows 2008 R2) and 7.1 (Windows 2012 R2)
Print Console software
Prior to upgrading to Prinergy Workflow 8.1, contact your service representative to ensure you have the correct version of Print Console installed.
Prior to upgrading to Prinergy Workflow 8.1, contact your service representative to ensure you have the correct version of Xpo installed..
Note: To run Xpo on Windows Server 2008 R2 x64 SP2, you may require an upgrade.